helpp with diff breather..

i cant get the air hose all the way n the breather, so far its only on halfway, is there a truck to getting it on, i have already used soap.

 

i took a pair of channel locks and worked the rubber hose to warm it up and allow it to flex out when the hose goes over the breather. Also did u get 1/4 I/D hose?

 

I would just say soap and a shit load of twisting

 

use a screwdriver to sort of ream the inside of the tube and stretch it out, then use a little dish soap and some good old fashioned elbow grease.

 

Heat the hose up alittle

 

I lubed the breather barb with a little bit of gear oil.

 

ok thanks i used 1/4 fuel line

 

yeah its alittle tough getting it on but it will eventually go on there.

 

i pushed as hard as i could and it only went half way

 

x2 it works best to get hoses over things

 

Just heat it up in a cup of hot water for a few mins