How do I measure for Leveling?

Thats correct. 20 front, 22 rear.

 

I think it may be FUBAR already so I probably need to look into replacing the entire pack. Any suggestions???

 

Do you want to lift ?

 

I guess it is possible that I purchased a truck that was leveled at the dealer. I will have my installer check for a strut mount spacer. I definately did not do it after I purchased the truck though...

 

Eventualy I do, but nothing crazy. I do a lot of back road driving, not Off roading. I also use it as a daily driver and do not want to sacrifice the ride quality too much.

 

Keep an eye open in the 2nd Gen B/S/T , stock suspension parts come up there every so often , I just checked and a set of TSB 4 leaf packs just sold yesterday

http://www.tacomaworld.com/forum/2nd-gen-tacoma-marketplace/

 

Maybe its the added weight of the additional airbags... I do have a full tank of gas too.

Then again it wouldn't surprise me if the specs for the shocks have changed a little over the years... All companies do that to some degree.

 

Thanks for all the help. I will go ahead and mount all the 5100's at 0" for now and wait until I can find a 4 leaf TSB shock for sale or look into purchasing a new set on the internet.

 

Good luck

 

I researched Tacoma shocks and ended up going with the Bilstein 5100's, I ordered them from Down South Motorsports, received them three days later, that was just a week ago. I installed the rears first this morning, started raining so I wrapped it up for today. I am gonna set the front on the middle setting. I just went out and measured my 03 Tacoma 4WD TRD and it measures 21 3/4 rear, from hub center to fender, 20 1/2 front.