How to install metalmiller emblem

Hey everyone, I just received my new emblem from metalmiller, and I just wanted to see how most of you have installed yours. My first thought was to just drill two new holes in the grill since the stock ones don't line up. Looks like that might be a pain tightening down the wingnuts from the back. Any other ideas?

 

Pull the grill off, very easy to tighten down a nut from the back side of the grille.

 

I threaded the rods into the emblem, then marked where they contacted the grill. Drill two holes, tighten the wingnuts and you're done.

Measure twice before drilling... total time should be about 10 minutes.