Howzit everyone

I like them a lot. Wish they had them in 18's when I originally purchased.

 

I rather the setup you have cause it has some meat to it. the 18's are nice but l think they lean more towards the low profile look.

 

What's the status? I just put these on my truck. I noticed water just pools in that spot.

 

Those rims are sick and that's one clean truck.

 

^^^^^^^^
I spy "Scotty's"

 

Now I know what my truck looks like with them on! I'm actually getting them too.

 

Thanks guys. Its hard to get the lighting to get a good pic of the rims but ill try to get some up soon. After washing it, the water just pools inside the rim where huli's started to peel. Doing my best to keep the water out to prevent this.

 

it may be worth shimming out the ring to create a gap big enough for water to drain.

 

The ring is fake so i don't thing you can shim it out. I also lifted a pre-runner....damn that was embarrassing

 

Looks super good on your rig.

 

yeah, my ring is fake too. adding a washer or 2 to each bolt might yield just enough room. I don't like how dirt can find it's way between the ring and rim with water pooling around.

 

Good Idea. Huli, did they warranty the rim?

 

Nope, 4WP HI gave me the run around for the last month. Not that I like giving up but I'm not holding my breath on it. Might plastidip the wheels or paint. Not sure yet. Your truck looks nice tho.

 

Damn. Yeah i figured id just do the same of it happens. I just found out they charged me twice for the rims and tires. Its always something with them.

 

Think I saw Raycie leaving as soon as I got there - Lots of Jeeps. Really nice to get outdoors today. Did the Kelaia Trail Hike first, then checked out Kaena's:

 

Nah.. wasn't me, but I did see my newer "twin" SB coming up the Makakilo hill all muddy.. I thought that guy was out at Kaena.. I got LB.. Funny.. you thought that was me.. almost could be.. lol.

 

I may venture out tomorrow or Tuesday depending on the weather.

 

Ahhhhh, it is your "twin" only SB...haha. I seriously need to add some bump stops to the rear.

Anyone have an idea for mounting them to the Toytec U-Bolt Flip Kit? Would Energy Suspension bump stops work, and if yes, how?? Bolt on or Welding???

 

I don't know if the Toytec ones were tapped for a plate, but the allpro ones I have were. If yours weren't tapped, you could always drill or tap for a bracket that has the bumps on them. If you don't have crazy lift, I still have the ones that came in my set. I didn't use them cause I used my timbrens... you are more than welcome to grab them. Also boss 4x4 sent me some other plates to use. You can play with those as well.