1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

I'm needing help with my CV Ball Seat in my double cardan!

Discussion in '1st Gen. Tacomas (1995-2004)' started by middlej13, Jun 10, 2023.

  1. Jun 10, 2023 at 6:28 PM
    #1
    middlej13

    middlej13 [OP] Active Member

    Joined:
    Feb 19, 2023
    Member:
    #418353
    Messages:
    40
    Gender:
    Male
    First Name:
    Josh
    Blacksburg, VA
    Vehicle:
    2001 Pre-Runner 2WD, Double Cab
    I had a lifted 2001 Prerunner, Double Cab, 2.7L, short bed 4X2, AT. I inspected my Front driveshaft and the CV Ball Seat in between the DC was shot. The pins inside it were worn out, so I'm now trying to find out how to go about this. Is there a kit to repair this? Any suggestions or tips would be greatly appreciated!
     
    Last edited: Jun 10, 2023
  2. Jun 10, 2023 at 10:20 PM
    #2
    Bivouac

    Bivouac Well-Known Member

    Joined:
    Sep 5, 2021
    Member:
    #376253
    Messages:
    11,580
    Northern Lehigh Valley Pa
    Vehicle:
    2000 Tacoma 5 speed 3.4
    Remains to be seen I bought the tires and wheels the rest came along
    I think your asking about rebuilding your cardon joint?

    on the front section of your drive shaft.

    Consult your local drive shaft shop .

    A good used drive shaft might be your lowest cost option.

    Pictures area very big help.
     

Products Discussed in

To Top