1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Installing Light Bar Switch 3rd Gen

Discussion in 'Lighting' started by justhaag, Dec 23, 2017.

  1. Dec 23, 2017 at 8:10 PM
    #1
    justhaag

    justhaag [OP] Well-Known Member

    Joined:
    May 9, 2017
    Member:
    #218611
    Messages:
    272
    Gender:
    Male
    Mesa, AZ
    Vehicle:
    2017 Quiksand Tacoma TRD Off-road 4x4
    Hey guys!
    So I have my light bar from Cali Raised all wired in and it functions flawlessly. Now comes the time where I need to swap over from the basic switch to an OEM switch and I have a few questions.

    I know I need to use an add a fuse, but I'm not sure if there are different sizes and if there are, which one I need. If someone could link me to one on Amazon, that would be great!

    Is there a way to tell which wires go where other than stripping the wire grouping and tracing them back, or by watching youtube videos in hopes of finding someone who has discovered the proper order of my specific harness?

    Also, what is the best way to connect the wires from my switch to the wires in my harness? Currently the harness has terminal rings on the end of each wire.
     

Products Discussed in

To Top