KC Daylighter install on a “roll bar/Heachebar” help

So I’m needing to wire 4 KC daughters on a roll at/headache bar just like Marty Mcfly’s truck in Back to the Future!! I have the lights and of course the vinyl light wraps but I don’t have a freaking clue on what else I need and how to run the lights to the battery. Currently I have Raptor lights in the grill and the sequential turn lights on my side mirrors. Do I need more input options to carry more power for the lights? I will last be running the 3x5 lights on a bull bar bumper eventually. I just want it done right. And again, I’m cluless!! Do I need wire hiders, longer wires, more fuses, more relays or what?? Thanks for y’all’s help. I’ll post a pic of what I’m going with.

 

I just hooked up some on my roof rack last week and ran the harness down the the inside of the trim on the side of the windshield. There is a little groove in there just big enough to stuff the wire harness. Then through the grommet on the drivers side of the firewall below the brake master cylinder.

As far as the relays and such the harness had both in line fuse and relay already included, but I am gonna install a relay/fuse block to clean up all the wiring in the engine bay as I have several sets of extra lights installed.