Keystone State Thread

http://ucscpa.com/

It's not really a hunting club. I know of a couple of them but I don't have time to hunt anyway so I'm not a member.

 

Oak Avenue and Baltimore Pike in Deleware County @ 5:15pm Friday. TRDOR DCSB MT. Survivor edition.

 

I think I've just seen the biggest spacer lift on a Tacoma ever

 

I wish I've taken a pic last year, when I was getting a Christmas Tree, there was this jacked up 3rd Gen Taco, with a winch mounted on front receiver... He must have at least 6" blocks on rear axle... I wish I've snapped a pic.

 

Anyone have a heavy duty rivet gun I could borrow or rent to install the Redline hood struts I ordered? I really cannot justify purchasing one, unless I have no choice.

Located near O.V. Mall, Lower Bucks Co.

Thanks in advance!!

 

If only you were closer. I have one

 

I work at JBMDL ( Ft. Dix ) almost every day. Are you anywhere near there?

 

I'm about 30mins from there what do you do. My cousin is ft Dix cop n my brother in-law is stationed there.

 

I am a DOD contractor, training support for the 421st Training Squadron, amongst other contracts. If your cousin works the gates, I have probably met him, although briefly!

 

I have a couple of them.

 

When you say heavy duty, you mean the one you need 2 hands for? I have both either way. Near Neshaminy mall

 

That's probably what he needs the two hand one. U might be closer to him most definitely

 

I used the smaller one worked fine.

 

I used a small rivet gun. There is a little movement. It bugs me so I drilled out the rivets in the bottom mounts and put machine screws in. There is still some flex. My plan is to bust out the mig and put a couple of tacks around the edge of the mounts to try to stiffen them up.

 

Didn't go fishing. You have to swim across the creek to get to my favorite spot, and I wasn't sure Atlas could swim it with the creek running a little high for this time of year.

 

Yup, the two handed type.

 

I can bring it home from work on Monday.

 

On unrelated note...
Today we (The Family) went to The Lights Fest in Kenneth Square PA. It was an interesting event with a few thousand attendees.

I also came across a nice looking 2nd gen over there

For sone reasons whenever I see a Tacoma with some rims or whatever, makes me wonder if they're on TW... Lol.
Like that clean white raised 2nd gen that followed me for a little while on the way to the event ...

 

Got the Redline Tuning hood struts installed today. Big thank you to HomerTaco for doing the entire job! ( well I DID have to drive a whole 20 mins. each way )
Yeah, in this heat he had a small patch of shade and got it done!!! Easiest install I ever did!