King Shocks Group Buy - Closed

700

 

What's recommended for people with a 2nd gen with no added weight up front?

 

Most common is 600

 

650

 

600, they recommended 650 for my 2nd gen w/ steel bumper.

 

chit i though stock bumper was a 650 so that's what I put in my order i just PMed DSMS to put what ever spring they recommend for a stock bumper on a second gen.

 

I've only researched OME but most all of their coils are 590 (credit for this to Headstrong.com )

• OME 883: 375mm in height, 590 pound spring rate
• OME 884: 390mm in height 590 pound spring rate
• OME 885: 395mm in height 590 pound spring rate
• OME 886: 402mm in height 660 pound spring rate
• OME 887: 400mm in height 590 pound spring rate
• OME 888: 405 mm in height 590 pound spring rate

 

I asked DSMS about mine with only Relentless Fab bolt on Sliders and possible plans to add weight in the future. They said 650.

Edit: Gen 2 DCSB TRD OR

 

10 more days!!!

 

I wanted to 'like' that comment but I wish they would just charge my card and ship it right away.... why wait?

 

now i will like your comment! you got a point there.

 

Are we at the minimum yet? My order for DK specific LT kings won't be in until the last minute, money still rolling in...

 

@iRodeMTB

 

post 379 pg 19:

 

Got it thanks, i started searching from about page 10 but got bored lol LT kings here i come!

 

Is there a discount for hydro bumps too, or just shocks?

 

What do they do different for Dakar Springs? Curious as I did mention that when I ordered but not sure if anything different was done.

 

Difren

Check out post 276 page 14, when I asked they change the end link on the standard length shock, its 1" longer. I asked if I could run the EXT rear stock setup and get the Dakar later. They told me not advisable, the shock could blow out if it compressed to end travel. They said I could change the end on the standerd length shock to the one shipped setup for the Dakar later. It would be about $80.00 for the new 1” longer end. They also said the shocks could be sent back to them and they would change out for cost and labor. To change the end you need aluminum V blocks to hold the rod so you can remove the end. This keeps from damaging the rod.

From post 276;
The Dakar rear shocks we offer are 1" longer and shorter ext/col lengths than the standard king rear shock.

 

This GB is for anything King. The discounts will vary from line to line, but there's still a discount.

For the 25001-119's they make those for Dakar's free of charge. You'd use part number 25001-119-D for the Dakar shocks.

Mike