1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Load Proportioning Valve Bleeder Screw Size?

Discussion in '1st Gen. Tacomas (1995-2004)' started by reallifeonhold, Nov 7, 2020.

  1. Nov 7, 2020 at 7:02 AM
    #1
    reallifeonhold

    reallifeonhold [OP] Well-Known Member

    Joined:
    Aug 26, 2020
    Member:
    #338947
    Messages:
    118
    Gender:
    Male
    First Name:
    Travis
    Vehicle:
    2004 4WD 5MT
    Does anyone happen to know the thread size/length of the bleeder screw on the load proportioning valve? I want to throw a Speed Bleeder on there to allow for one-man brake bleeding.
     
  2. Nov 8, 2020 at 8:41 PM
    #2
    reallifeonhold

    reallifeonhold [OP] Well-Known Member

    Joined:
    Aug 26, 2020
    Member:
    #338947
    Messages:
    118
    Gender:
    Male
    First Name:
    Travis
    Vehicle:
    2004 4WD 5MT
    In case anyone ends up searching for this...

    The thread is M7x1, 32mm.

    I used this one from Napa (same as the ones used on the front calipers when doing the Tundra front brake upgrade): https://www.napaonline.com/en/p/NDP6751572

    The Toyota p/n is 47547-27030
     

Products Discussed in

To Top