Long Travel BS Thread

Bypass will go in fine

 

thanks! I figured it should.

 

i prefer big league chew. Grape flavor.

 

Can you get a coil bucket gusset in there? Or remove the uca bolt?

 

Love the plate design much better than the tube, they have the for Ford Raptors

If someone made them for 1st gens I'd pick one up...

 

Yeah this fits with their coil bucket gusset which I also have on my shelf. Weld it all at once since they intersect.
The bolt would pass behind the bypass mount in this configuration.

 

Anyone need parts?

 

looks like it would work but shit will be even more of a pain in the ass then it already is.
Can you do the the single upper bolt mod for the coil over though?

 

Please explain... pics?

 

"Prerunner 4x4"

Hhhhhmmmmm

 

someone on here has done it. easy drill hole in coil bucket so you only have to pull the one bolt out vrs 3. Not recommended if no crossover support is installed or some sort of other coil bucket support like engine cage/ gussets.on mine drive side bolt faces the cab, and this may prohibit that bolt the room to come out. I drilled the holes no pics to show but its pretty straight forward.

 

No idea
Saw in Facebook market
Just sharing

 

Anything helps him and Lo, planning on making a good size donation for a Christmas surprise for them.

Hes currently stable, taken in and out of the induced coma for a couple hours each day and his vitals stay stable through the process.

Has a trec in for his lungs, most of his breaths are on his own but the machine does help sometimes.

Currently getting his broken bones sorted out this week.

Hardest part is over i believe, his IS going to survive. But time will tell how serious his brain injury is and wont fully know until about 6 months to a year for a full diagnostic. again anything helps them get through this so he can focus on recovery and not financials so he can be back faster to support his family.

 

Thanks for posting man... We are all pulling for him!

 

Do you need a locking diff?I have my old rearend, I had to get a new knew one because one of the tubes were cracked and the gears blew lol. But the actual elocker still works

 

I am looking for the rear axle housing off a Sport if anyone has one laying around?

 

R u talking about the locker actuator only?

 

No Its an entire third member gears are bad though. Its a complete rear end so Youll have to pull out the locker third and have new ring and pinion put on it then just put it in your rearend/ housing.

 

Anyone in the LA area know where I can get spring perches by this weekend? Don’t have time to go to Corona.

 

Try 4 wheel parts? I know they're not very good for much stuff, but might be your best bet. They carry synergy, artec, trail gear etc.