MBRP 3-Inch XP Turn Down Exhaust System install on my new 2020 6spd MT Taco

you didn't put micro fiber towels on top of your jack stands?????






j/k, that's a clean truck!

 

My thoughts exactly-- I lived close to summit too so I can get any clamps I need if the muffler is a little shorter etc. How does it sound and which borla muffler did you go with?

 

lolol jack stands always trip me out. Lol I was out of clean ones

 

I went with the BORLA 400487, it is single in dual out.
Shorter than my original MBRP by about 5", so I had a shop fab me some short 5" extension and clamped them on with u-clamps and lap band clamps. Not the cleanest solution, but it works. Might end up just having the tailpipes properly extended at a weld shop nearby.

With your turn axle turn down, I do not think you would have a problem mating it up to the muffler, as I did.

 

Update-- I love the exhaust. Little Ripper.... makes me think I'm faster than I am. Lol. Looking into a HC bumper now----