MESO Interior Chrome Delete Kit

2 of 3 of the climate rings popped the whole thing off (the clear lens/projector behind the display lens). Didn’t seem to do any damage, definitely wasn’t expecting it though

 

I think you are referring to the light diffuser. It's happened and perfectly fine, just snap it back into place.

 

All of mine did this. Figured it was because I didn't look at any install instructions

 

Installed my climate rings today.
Before

After

 

MUCH better

 

Nah I watched the video and it happened to me. The 2 that held on just had a stronger hold, I even stabbed the hell out of my finger on a slip with the pick tool

 

I did the climate rings yesterday - after watching the video I assumed they would pop off fairly easily. It took much more pressure that I'd assumed and two almost made it into the back seat when they popped loose. Maybe I need a better pick tool!

 

Finally was able to install my Meso vent rings, climate rings , TRD start button , and chrome delete kit.

Now patiently waiting for his door handles

 

The last of my chrome deletes came in today. Gonna take a picture when I install it tomorrow.

 

I’ve said it before but I really
Love how the MGM rings flow with the dash colors. Looks great!

 

Speaking of interior trim... you guys gonna restock the stealth knob kit any time soon?

 

Ran out of the micro switches so I have more on order. As soon as I receive them I’ll make more kits

 

Awesome. I want to do that mod to free up a switch port or two on the lower center console. I wish someone made a decent voltmeter that wasn't straight chineseium.

 

They do, its mostly for the RV world. A victron battery monitor is the one that springs to mind. Its a little bit larger than a switch blank, however. If you want one that installs clean on the dash, sorry, it's gonna be junk. It isn't the sensor, its the way it's wired. For a volt meter to be even remotely useful for measuring battery charge, you need a set of wires directly tied to the battery with a shunt, and you need firmware that can correct for amp load.

 

I don't need anything too serious- the way i have it set up it's spliced into the harness for my brake controller. The whole point is basically to see if the voltage is low before start (old/dead battery) and to see a normal system voltage post-start (checking the function of the alternator). An ammeter would be nice, but a master voltmeter and ammeter would be a bit of a job. And also hard to fit into a plug port. All i'm saying is that I wish someone did something a little more substantial. I'd pay more for a little more quality in my electronics and plastic.

 

I gotcha. That would be nice, I wish that existed too. I seem to have slightly better luck with the mictuning brand - still cheap crap, but its outlasted the other cheap crap Ive kludged up in my camper. They are the only ones that dont use wires thinner than a doll's hair on the internals. Which is to say their internals still aren't close to quality, they are just better than the others.

 

Yeah mine's a MICtuning

 

Any time line for the vent ring and interior chrome delete in black will be in stock again?

 

2-3weeks. In production now

 

Waiting...as patiently as I can.