Meso Ultimate turn signal problem

I have installed the turn signal on my Tacoma and it work for a few minutes. I’m wondering if the my Total Tail Stage 1 rear tail my be the cause of the problem with the resistor ? Thanks

 

@MESO

 

might want to post this in Meso's thread in the 3rd Gen BST section. but check the pins on the light, i heard they sometimes bend a little and need to be straightened out upon installation.

 

@MESO

 

Thanks

 

Do you have any ADD ON resistors installed?

 

Yes it’s on my rear tail lights . When I installed the ultimate turn signal it my driver side works fine but the passenger works for a few seconds

 

Yeah, disconnect the resistor in the taillights. Mine would flash only once with the resistor connected.

 

disconnect resistor. My turn signals have a resistor installed. When you add another one(in tail light) it overloads.

 

Okay thanks. So i had to take out both resistor out of my tail light and It work fine