Metal Fabs in the PNW

I am slightly new to off roading and this forum in general. I have found some metal fabricators such as BAMF, Pelfrybilt, SOS, etc. These are located south of me. Just wondering if anyone has found any good ones likes these located in Washington state. Looking for some good sliders for my new truck. Thanks!

 

Cruisin Off Road in Chilliwack, BC is the bomb. I run their sliders and I've yet to see anything better. In the process of getting some other goods fabricated by them, too.

Plus, at the current exchange rate, a set of sliders would essentially run you the cost of a cup of coffee.

 

Sweet, I will look into this. Thanks!

 

FYI, the guy that runs the shop is out on vacation from today until next Tuesday, so if you contact him, you probably won't hear back until early next week.

 

There's Marshall Fabricators in Vancouver, WA too. Seems like a lot of folks in the Portland area have used his sliders. He's active on TW. Here's his thread.

 

Thanks! I did find this one as well, but his site says not taking any orders at this time. Not sure if he's over booked or if he's done for good?

 

Bummer. Hadn't seen that. His thread says June or July he'll start taking orders again.

 

Friend of mine works at Mule Expedition Outfitters in Issaquah. Pretty sure they do fab work.

 

There is Metal Tech 4x4 in the Portland, Oregon area

 

Cool, thanks! I don't mind driving a little into Oregon since I am in Puyallup.

 

I did not know this. I thought they just sold accessories as my friend buys from them from time to time. Thanks!

 

Thanks for doing the dirty work. Guess I should of looked at his thread. I do like some of the work I have seen, so I'll definitely check it out.