1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

My Truck Bucks After Throttle Sensor Was Replaced

Discussion in '1st Gen. Tacomas (1995-2004)' started by thehadmatter, Feb 4, 2020.

  1. Feb 4, 2020 at 5:42 AM
    #1
    thehadmatter

    thehadmatter [OP] Member

    Joined:
    Jan 1, 2016
    Member:
    #173680
    Messages:
    22
    Gender:
    Male
    Charlottesville, VA
    Vehicle:
    2001 EXT CAB SR5 2RZ-FE 5spd 2WD
    2001 Tacoma Base Extended Cab 2WD 2RZ-FE 2.4L 4CYL 5SPD

    I recently got a DTC for P0120 Throttle Position Sensor A Circut and P1130 Air Fuel Performance Fault (Bank 1 Sensor 1) I replaced the throttle sensor and the throttle code went away but the Air Fuel Sensor code came back and then the engine light turned off then back on again for Air Fuel Sensor and then back off. However, in the last two days and especially on a cold morning the truck will buck hard in 1st and 2nd gear and continue to buck in higher gears but less violently and there is a code back for the Throttle Position Sensor and Air Fuel Sensor (Bank 1 Sensor 1) but no check engine light.

    Anyone have any idea?


    ***UPDATE*** It turns out I got a bad sensor from my parts guy. Got a new new sensor in and it runs perfectly.
     
    Last edited: Mar 19, 2020

Products Discussed in

To Top