New England Mod & Meetup Thread:

It sold, I am trying to get one this winter though.

 

Any thoughts on rebuilding them? I haven’t looked into it.

You don’t have boots right? So the rack just pulls in junk?

 

Going to try rebooting them again soon. I’ve tried 2 and both rip free at the rack end.

but yes, plan is/was to try and rebuild one

 

Want to come up with something for my hitch connector? If i do anything I'm doing it with a dollar tree (maybe dollar general) cutting board and jigsaw

Food before sloshing around the woods? send it.

 

I eat the whole time anyway.


I have a swing out with folding table… wonder if y’all could repurpose it??

 

Oh - I mean the mount for the trailer wire harnesses. Way smaller beans than a swing out, but thanks for thinking of us!

Jared where do you get the hot nuts @crashngiggles @CTSpruceMica

 

Do it, I want to make some knuckle pod mounts.

 

Oh hot nuts.

Yeah I can, I actually still have the drawing. I’ll take a look into it that wouldn’t take any departure or spare tire space

 

It..... Was a bit boney today. Hahahaha

 

Gotcha, Jared may still have the harness holder thingy from when we did hood bumper. Not sure if it’ll work for you. Not sure what you’re planning tbh..



Better hope they don’t get the hot nuts at the same place they get the skittles.

 

It's been a couple years since I've stretched my legs hahahah.

 

The mud between the climbs was actually the poor part. There's one tree down that folks with skids And sliders can get over. But there's a few spots where there's been some decent erosion around high center rocks that anything under 33's is probably dragging

 

tell me more about this swing out with table, it’s on my wants list, just way down right now.

 

I’ll get you pics n stuff soon. It’s buried in the garage.

 

Hi

 

This was a cool watch. Guy cuts a window into the side of the block and replaced the pan with a clear pan so you can see everything. And then overfills with oil.

https://youtu.be/VaTbfvzNbxQ?si=mXoCDH_kzAcEFWO5

 

Great little mod day with @Brownmatthall at @TacoTuesday603 !
Thanks guys! Works have taken me a while weekend to do what we did in hours.
@TwistedTLM4 , finally got the DKs in!

My list was; DK lowers, SPC uppers, cv axle. Needed to do a tie rod end but that’s a future John problem.

Matt and I had a great time using all the big boy sockets and wrenches we never use on stock. Lots of 22mm, 24mm and a 30 for the front LCA bolt

@kwanjangnihm ,@MQQSE ,@SACTOWN ,@MarX did a little wrenching today and Matt got a beefy chop kit installed… cause I ripped the last one off

 

Heck yeah!

 

Very nice