NJ B.S. Thread

Yup. I screamed "WENDEEEEEE."

Then I thought. "Geez I HOPE that was Wendy" LOL.

 

I might have to swing by your place and maybe burn on my cross member for my trans skid and maybe we can cut and bolt up my trans skid soon.

 

me too an I need $$$$

 

Side note... If you need a filter tool or strap wrench to remove your oil filter, you're over torquing them during install

 

Only a 20% duty cycle for MIG. No bueno. Half of the point of me getting a new welder is stepping up to a better duty cycle.

 

Hand tight for meh

 

Hah. I'm 6'4" and 300 lbs. I think I got man hands covered. Still can't get it off.

 

Thats what she said

 

Blue pill?

 

Stab it with a screwdriver

 

I was gonna say, who's man hands

 

Thats how I drain mine ... punch a hole in the bottom.

Rotating the tires today after work and then possibly wheeling with Ant

 

Start and run the engine up to Operating Temp, cut the motor off, filter should be a bit easier to get off with it warmed up.
If not ..... start thinking it might be crossed threaded.

Use to see this at Toyota when Jiffy Lube's finest would impact them on. Typically this procedure above works.

 

I've only needed to stab with a screwdriver once. Otherwise it's easy peasy.

 

When I was in a shop ppl would bring their bikes in with barely any filter left and be like yea we tried everything to get it off...

I'm like yea I can see that

 

@Sub-Zero I forgot to take pics of the sliders, but it's pretty much the weld on kit 4x innovations sends. let me know if u down. I just got word I will be working this Saturday, so I'm kinda screwed for this weekend. how's ur schedule like?

 

You a carpenter?

 

I always do hand tight then 5 turns.

 

Yea I use lug nut torque specs on my filter to be sure it doesn't leak