1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site
    Quick Links: What was this rear bumper part that’s now missing? Help with OEM Part #s 4x4 V6 Dbl Front side marker light falling out constantly Tacoma 1995-1999 Borla Cat-Back Was this a reasonable charge to diagnose/replace ignition coil? Wiring lights to turn on with truck, but turn off with hi beams

Noises

Discussion in '1st Gen. Tacomas (1995-2004)' started by old grouch, Sep 9, 2023.

Page 2 of 2
  1. Sep 11, 2023 at 6:59 PM
    #21
    RedManRocket

    #21
    RedManRocket Well-Known Member

    Joined:
    Mar 18, 2015
    Member:
    #151238
    Messages:
    2,297
    Gender:
    Male
    First Name:
    Red
    Sonora, Central Cali
    Vehicle:
    2002 Double Cab LT
    Esb 5.5 with Kings Mcneil 6.5 fenders Other stuffs
    Try this, try to tighten, and then loosen.
     
    RedManRocket, Sep 11, 2023
    #21
  2. Sep 12, 2023 at 8:46 AM
    #22
    old grouch

    #22
    old grouch [OP] Well-Known Member

    Joined:
    Dec 14, 2014
    Member:
    #144242
    Messages:
    488
    Gender:
    Male
    First Name:
    Stan
    Colorado Springs, CO
    Vehicle:
    95 4x4 V6 Extra Cab
    E-Locker SS Skid 2" Lift
    Thanks, did that already. No joy. Trying to find a puller that will fit in there. Gonna be really pissed if I have to pull the radiator.
     
    old grouch, Sep 12, 2023
    #22
  3. Sep 12, 2023 at 4:00 PM
    #23
    old grouch

    #23
    old grouch [OP] Well-Known Member

    Joined:
    Dec 14, 2014
    Member:
    #144242
    Messages:
    488
    Gender:
    Male
    First Name:
    Stan
    Colorado Springs, CO
    Vehicle:
    95 4x4 V6 Extra Cab
    E-Locker SS Skid 2" Lift
    Okay so I got it done! That tensioner bolt on the P/S pump is a certifiable PITA. I got a rental puller from O'Reilly's that enabled me to get the idler pulley off. I had to remove the lower fan shroud but it worked. The P/N is 67020 in case anyone else runs into this problem. Thanks for all the help.
     
    old grouch, Sep 12, 2023
    #23
    RedManRocket, Bivouac and Red_03Taco like this.
Page 2 of 2

Products Discussed in

PGN (10 Pack) 6301-2RS Bearing - Lubricated Chrome Steel Sealed Ball Bearing - 12x37x12mm Bearings with Rubber Seal & High RPM Support
$17.45
To Top