NW WA Meet / BS Thread

And done

 

There are few things I would have done different if I had to do over again. Would have made the half cup holder smaller to have a bigger spot going between the hole for the shifter and half cup holder.
Also would have built up underneath close the main big cup holder and not have that hole in the upper right of it. Didn’t plan the transition to the shifter hole very well. If that part was $100+ I’d get another and redo it better.

 

Where does it sit in L4 I’m assuming your in H2. Is your other shifter a Taco box?

 

I want to say I’m in l4 in that pic. Had to put it in l4 to get the cup holders on with out taking the knob off. I could be wrong tho.

Yeah the little black knob is the crawl box

 

Yeah I was wrong. This is 4lo



this is 2hi

 

You should use a crown Victoria bottle bag for the boot shifter

 

That is a crown royal bag. Crown royal apple comes in green

 

I thought the bag looked familiar but wasn't 100%

 

The tcase shifter by the 6spd shifter is your 2wd/4wd shifter or the taco box? I'm assuming the latter and the bottom shifter your 2wd/4hi/N/4lo/engage the front wheels? Hence the shift knob placement.

What did you do for drivelines?

 

front shifter by the 6spd is L-N-H from front of the truck to the rear. its the crawl/taco box. the one that destroys my cup holders is the FJ Transfer case with the J shifter. I used to have Twin sticks there but i got a new Tcase and didnt feel like going into it and doing the twin stick mod. plus, with the crawl box i have 2Lo if i need it.

 

Ok, I was all confused for a min with your shifter position and explanation. I had to remind myself to kiss, it's not a piano.

 

for the drivelines i had the front drive shaft lengthened and the rear drive shaft shortened into a one piece. I have 4.56 gears with ARB locker in front with 4.56 gears with stock E-Locker in the rear

 

Gotcha. yeah if you go into my build thread you will see everything in order. ive redone the shifters a few times along with the center console

 

I swear every time you dive down your mods in this thread I start searching for your build thread but my ADD kicks in and a different thread you commented on piques my interest and I never make it that far.

 

just for you
https://www.tacomaworld.com/threads/my-build-thread-v3-0.128687/

 

Ok I've been in there before.

Kinda hard to not remember a red acab with matching canopy and lined bottom. I'm committed to make it past the first page this time.

 

most things are in the 1st post. only other interesting thing is the engine swap around page 20-25

 

Thanks for the tip. Works great

 

100% duty cycle for the win. When your friends with no compressor aired down and assume they can just use yours, the dual keeps on pumping tire after tire after tire.... After...... Tire.

 

I was that friend without OBA/capable inflator And thanks to @WrecklessAbandon and @Bertw192 For hooking a homie up on the trails ... I’m gonna order mine this week