OEM Chrome TRD exhast tip $50 shipped *Sold*

*Sold* Takeoff from my 2017 OR TRD - 5300 miles. Some soot stains and heat coloring on the inside and on clamp, but in good shape and clean chrome outside (So Cal truck - never saw a salted road or water crossing). $50 shipped, or $35 local PU (Hemet, CA). Paypal or cash only.

 

Do you think I'll have to weld onto my 2008?

 

Whats the diameter of your pipe tip, and how far back does it get smaller? I will post a pic of my pipe with measurements how this mounts.

 

If I measured correctly, The diameter measures approximately 2 5/8 in.

 

Outside diam= 2-3/4”
Flair length = 4” (apx)
Pipe upstream of flare diam = 2-3/8” (apx)

 

It may work- how long is your flare section, and upstream from the flare diameter?

It looks like the tip clamp will go down around a pipe as small as 2-1/4”

 

My flare length is also about 4 inches. Mine looks identical to yours.

 

If you are sure this will fit and you are interested, PM me your Paypal email and I will send a Paypal invoice. Thanks!

 

is this just for aesthetics? I saw it also at the toyota ship. Just curious

 

Yeah, came with my truck, either It was going to be scraped off or pinched by a rock, stolen or sold for beer money.

 

Sorry this was so late, use the quote reply for replies (like this) otherwise the receiver does not get an alert.

I had the same issue - did you get it off? If not, you have to simply push out the two half pipe locking inserts (see post pic #6 above) towards the rear of the tip (slide them along the smaller diameter pipe- may need a bit of WD40) by placing a flathead screwdriver blade on the lip and tapping them out.

 

Yea after losening the clamp, take out the locking half circles by pushing them back out and then the chrome tip comes off.