Ontario BS Thread

Question gents...who's the caretaker of the wheel well template these days...or who is willing to loan me their off the original template...?

Was under there pressure washing and passage side is flapping half off.

 

I got better question here, who can cut me one or two? don't start me on my cutting skills

 

Well, I'll be cutting a pair...so. ya lol

 

Ya dood, I'll get my bandsaw blade back in tune, stack and clamp a 4 or 5 layers and cut multiples in 1 pass. Move em over to the drill press and drill out the mounting holes. Longest part of this exercise is tuning the band saw lol

 

put me down for one then

 

Find me the template lol

 

@Shveet whats the thread name you made with template

 

found it!
https://www.tacomaworld.com/threads...rd-rock-guards-template.621635/#post-21190925

 

I have a template from @Shveet that you can use. I'm in London near the 401 next time you pass by.

 

Might take ya up on that...you around boxing day? Early afternoonish?

 

Yes should be. If not I can leave the template in the mailbox for you.

 

I think he gave me the templates, cant remember if I returned them ill have to check

 

No worries, gots an angle. I seen a twin to your Marguis very recently

 

It might have been it cuz i dont gots it anymore.
Last pic of the ol gal

 

Did it move SW?

 

I believe st Catherine's area

 

Newp, not the one...

 

Can I get in line for a set as well?

 

get in line

 

Do you get clean-cut holes with the drill? When I used a drill for my headlight gap fillers, the holes turns out messy. I resorted to a hole punch.