Oregon and Washington BS thread

@Chickenmunga
@JoeTacoma02 @jammdogg @04LTtacoma @kitsym

 

follow up on Killer Burger

Service is on point

waited a while today because of the deal,

burger is imo oversauced. too much peanut butter sauce, needs dialed back a notch, can't taste much else of the burger

i also went on wednesday and had their mushroom burger, and there was so much cheese (although it was good), it become repulsing...

 

Cant remember what they call it but Killer burger has a blackened burger with bleu cheese that was pretty damn good when I had it

 

Damn! We ended up going to the casino today in order to get over losing a bid for a new house.

If we didn't have the buffet I would go check it out!

 

Sorry Mike. How was the scouting of TSF?

ARGH! Didn't know it was yesterday. I've been a little hesitant to try any peanut butter burger. Have you heard or been to PBJs Grilled? I recently discovered this place and heard it is pretty good.

 

There is a place called Clarks in downtown Hillsboro that has a PB burger. I was super hesitant to try it but, damn, it was pretty good. Good quality meat but a little expensive for a burger.

 

I like PB but that sounds pretty bad.
TSF turned out well, I have some things to mention in the other thread once in done cleaning house today. Why aren't you coming @JoeTacoma02 ?

 

They came from All Pro. A guy in San Diego ran them for a couple months then went full LT.

 

I broke one. Although I did hit the ditch doing ~30mph.

 

Well would you look at that! Okay so you're the first I've seen!

 

I'm going to stick with TC axles, thanks though!

 

Its a lot more common on the desert guys. I remember one guy in AZ broke like 2 or 3 LCA's before going with after market ones. Definitely not as common up here though since it usually happens at higher speeds

 

If you need help with the install let me know, I just replaced my (stock) LCA's and axles a few weeks ago so it's fresh in my mind and I'm just a few miles west of you. I also did the ECGS bushing, if you are going to do that you can use my install tool from them.

 

Don't AP and TC both get them from currie? My extended axles I bought thru AP are just axles from currie.

 

What a fatty!

 

Will do thanks!

Are they? I might snatch his up as spares then and split it with @dakotasyota, I'd rather run new shafts just so I know it's new. Everything else is might as well include axles

 

Looks like you dropped some coin on that 10/22. Custom barrel? Bruiser of a groundhog too!! You do anything with it, or just leavin it for the yotes?

 

They're both made by Currie. All pro just has there's powdercoated silver.
I actually just split one with NateMob... Meeting him at Rock Therapy to pick it up.

 

Any of you Washington guys have a good shop in the Tacoma or Puyallup area that can put in a leveling kit? I don't do any off-roading it would be just for looks and to accommodate a little bigger tire. Michaels Toyota in Bellevue will do the work but I've heard its about ten times more expensive than anywhere else.

 

Which type? Between coil and top hat, or top hat and coil bucket?