Paracord grab bars

Bump

 

Umm.. anyone who has replaced their driver A-pillar handle want to sell me their OEM handle? I was drilling mine for an accessory and the bit wandered and chewed up a good amount of the plastic / rubber covering. 2014 gray (I think they are all the same though).

(apologies to OP for the threadjack, this just seemed like a great place to find a handle)

 

Could I get a set two, only the four ceiling handles though? No headrest.

 

Sub'd

 

Sent you a message!

 

Just installed my set of paracord grab handles from @08yoter and they look great! Really strong and well constructed

Driver's seat


Front passenger's seat


Rear left passenger's seat


Rear right passenger's seat

 

Op is the end for the bolt just left looped open ? I’m wondering if a set of these would work for my cap rack. Way cheaper than buying the prinsu ones.

 

Yea, there are tiny loops on there just big enough to slip the bolt through

 

Newlife yes the end just has a small loop at the ends. I’ll send you a message with a few pictures

 

I saw some pictures on a few of the early pages where someone slipped these over the stock handles. I just want to confirm that if I buy these they will still be able to work that way. I'm not a huge fan of the unfinished look associated with compeltly replacing the stock handles with these.

 

once i get my trailer squared away if you are still making these ill order a set

 

PM sent

 

Sub'd and added to my mod list

Trying to figure out colors and areas wanted..

Any luck/pics on covering the exposed screws mentioned earlier if you completely remove the grab handles?

Thank you!

 

For them to cover the stock handle you have to ship me your handles and I would wrap them and ship them back to you.

 

No I haven’t been able to figure a way to cover the exposed screws. A 3d printer is the only way I think!

 

Sounds like a plan, I'll send you a PM

 

Those are sweet, did you just rip the plastic ones out?

 

Is OP still around?? I've got a conundrum.

 

I wrapped both mine in about 15 min. Very easy to do via YouTube..

 

my driver side one finally stretched out, after 5 years.. I had to put the stock handle back on. @08yoter