Poly body mounts for 3rd gen Tacoma?

Putting a 3rd gen frame under a 2nd gen, apparently body mounts are different according to part numbers. Till the body’s off I can’t tell for sure. Just curious if anyone knows of poly body mount kits for the 3rd gen. Searches bring up nothing.

 

they aren't recommended due to cracking the radiator support sheet metal. the poly bushings don't have enough flex.

 

I’m assuming that’s an issue if not replacing all the bushings. But I get it. Toyotas just so damn spotty in me getting parts ina. Reasonable time lately that I don’t want to drop the 500 bucks on all oem ones. Ideally I’d just reuse the stock 2nd gen ones if they fit. But I haven’t pulled the cab yet.

 

I’m not sure if this helps you, but your question reminded me of this thread.

https://www.tacomaworld.com/threads...dy-mount-kit-group-buy-round-two-open.763759/

 

Ohh, they do exist.

 

My experience so far is the exact opposite.

 

okay, just don't be surprised when your front falls off

 

https://www.tacomaworld.com/threads...or-body-bushings.636828/page-19#post-27887464

https://www.tacomaworld.com/threads...or-body-bushings.636828/page-19#post-27875313

OP, sounds like you have some experience and maybe it’s different if you’re replacing all of them, but I’ve seen some fronts end ripped apart with the poly bushing on them. It’s wild.

 

It was broke off with the stock mounts.
Now I'm just trying to keep my headlights in since they are probably the worst retention design out there

 

Yes, its just like drivetrain mounts. Either do all mounts in poly, or leave all of them stock.