ProForce's Base Camp Build

Nice build man!

 

Thanks!

 

My in-dash touch screen radio is For Sale. Offers will be considered. Free local install and open to shipping

http://www.tacomaworld.com/forum/bu...oneer-dash-touch-screen-avh-p8400bh-w-xm.html

 

Love your rig man

 

Thanks man! Btw i responded to your PM about the lighting. Hmu

 

Responded back! haha

 

How many total inches of lift do you have from your set up?

 

The front is a 4" spindle plus about 2" from preload on the coils but the bunper and winch weigh it down to about 4.5 to 5" total. Rear is between 3 and 4 total

 

Nice, I really like the look of your truck and all the lighting.

 

Hey man i have electrical question for you.
I need some help here with electric issues, I have been having for while now. Can't seem to figure it out.

Here it goes are my issue

1. My cluster gauge backlight will get brighter and dim.
2. My Voltage meter on my obdII will fluctuated from like 14v to 12.56v when idle and driving.
3. My AC blower will turn up and down while driving and idle.
4. My dual battery gauge goes up and down with the voltage meter reading.


The weird thing is it only happens when it is hot outside or when engine is fully warmed up.

I have check my ground wires to the battery and even sandpaper the main terminal.

should i resurface the positive terminal with sandpaper? when i mean sandpaper i have one of these.

please help.

 

@Manwithoutaplan thats tough! Electrical issues like that are hard to resolve. The only things i can think of that might be causing problems like that would be alternator or your dual battery controller or the selenoid. Most likely it would be the alternator though. When the AC is turned on you put a heavy load on the belt which affects the performance of the alt. You could also have a cell in 1 of your batteries going bad too. i would start first with a load test of both batteres and the alternator to see what the results are. Then make sure your controller is not causing the battery isolator and selenoid to be acting up. Its going to be tough to narrow down though

 

Great looking truck man!

 

Replaced one of the ohh-sh** handle bolts with a ram mount ball to mount my x-grip too. Came out pretty sweet!




Now i just need a dedicated power port on that side. Im thinking a female usb in the a-pillar.

 

Dual cameras front and rear. Finally finished it.

 

Also got clever with the mic clip to avoid drilling

 

I like both of these pictures. I may be changing the location of my CB, and this might be a nice choice.

 

What mount did you use for this? Thanks ahead of time?