1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Rear Driveshaft to axle Flange bolt size?

Discussion in '1st Gen. Tacomas (1995-2004)' started by Alderleet, Oct 18, 2013.

  1. Oct 18, 2013 at 1:09 PM
    #1
    Alderleet

    Alderleet [OP] Ace of Spades

    Joined:
    Oct 16, 2011
    Member:
    #65324
    Messages:
    1,125
    Gender:
    Male
    First Name:
    Nick
    Salty Hell
    Vehicle:
    '00 Acc Cab TRD 4x4
    Hey, I need help figuring out the thread pitch, and size, on driveshaft bolts.

    When I last took my shaft off, I was forced to use a 12pt socket, and slightly rounded a couple of the bolts. My bad.

    Anyway, I'm replacing my carrier bearing, and I will be taking the shaft off again. I'd like to replace the 4 bolts/nuts connecting the rear of my driveshaft, to the rear axle flange.

    I've read they are grade 8 hardware, and that's about all I know.

    Anyone know the thread pitch and length?

    Thanks.
     
  2. Oct 19, 2013 at 5:56 PM
    #2
    Alderleet

    Alderleet [OP] Ace of Spades

    Joined:
    Oct 16, 2011
    Member:
    #65324
    Messages:
    1,125
    Gender:
    Male
    First Name:
    Nick
    Salty Hell
    Vehicle:
    '00 Acc Cab TRD 4x4
    No one?
     

Products Discussed in

To Top