Rebuilding lower heim on 2nd gen

Well my camburg (or SAW) coilovers have had a nasty squeak coming from the lower grins for close to 8 months now, just been spraying lube on them to shut um up. Now I want to address the issue correctly.

Anyone have a good write up on what's needed (tools and parts) to get the job done?
Good info to get them quiet once rebuilt?

Thanks guys

 

Lower heims* damn auto correct

 

We sell the 5/8 bearing that you are looking to replace on your coilovers. Check it out here...
http://camburg.com/all-products/00-06-tundra2/camburg-coilover-replacement-parts/

 

Thank you.

Do I just need the bearing and snap ring?

 

Snap rings are usually good, I would get one just in case, they are only a dollar.

 

So just the bearings then

 

Yes. Just the bearing and do yourself a favor and order a new snap ring.

 

Thanks guys.

Any writeups on this?
I've never done it before.

 

I would suggest pulling the entire coilover off, to make working on it a lot easier. Then just pull the snap ring off of one side and pull/push the bearing out, then clean it up a bit to get any random dirt out of there and put the new one in and then the snap ring and you're done!

I don't think those bearings are press fit in, but I could be wrong...

 

Big thanks to the both of you.

 

Just ordered 2 bearings and 2 snap rings.
Thanks again.

Aloha

 

Kayla can probably give you more details, seeing as how she works there lol, but I think I covered the basics pretty well. Good luck!

 

I'll bang it out when I'm in there swapping out the hubs and bearings.

 

Got the parts in today.

Huge thanks for the shit load of stickers that came with them.

 

I'm a sticker fan

 

STEEEEEEKERS are the best