1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Rims/ trimming with 33x12.5

Discussion in '2nd Gen. Tacomas (2005-2015)' started by GiggityBurns, Jan 15, 2021.

  1. Jan 15, 2021 at 2:30 AM
    #1
    GiggityBurns

    GiggityBurns [OP] Member

    Joined:
    Dec 19, 2020
    Member:
    #350117
    Messages:
    20
    Gender:
    Male
    Vehicle:
    2009 Tacoma 4x4 TRD OR
    So I’ve done a fair about of searching throughout the threads but I noticed there weren’t many specific threads about this for 2nd gens.

    I prefer to run 33x12.5s because of the width, but I wouldn’t mind running either 285/70 or 305/75. With that tire size, has anyone ran into big issues like rubbing even after chopping off a lot, or will it just be the typical cab mount, fenders, and bumper trims?

    I already know I need to cut a fair amount regardless, so what offset/ backspacing would be optimal. Also what size, if any, wheel spacers would y’all recommend?

    It’s probably useful to mention I will be running approx. 2-2.5 inch lift with SPC Light Racing UCAs up front and Headstrong AALs in the rear.
     

Products Discussed in

To Top