Scangauge 2 X-Gauge programming (oil pressure)

I have been looking around online to try and figure out how to program my scangauge 2 to show oil pressure as one of the 4 displayed monitored values.

Does anyone have their scangauge setup to do this? Is this even possible with a 3rz 2000 OBDII Tacoma?

 

Have you tried this?
https://www.scangauge.com/support/x-gauge-commands/

If its not there, it may not be an option for 1st gens. (not even sure its possible on my 2012)

 

After looking around on that part of the website, it seems that the 96-02 Toyota's use the ISO OBD protocol which does not provide oil pressure data.

I figured that since there is an oil pressure sensor in the engine, that I would be able to read information from it via my scangauge. If I were to guess, the sensor is designed to do just that: "sense". Not read numerical oil pressure values.

Other people have done DIY installs of oil pressure senders in their engines, so I guess that would be the way to go if I wanted to get an oil pressure readout.

 

Correct.

Basically an idiot light in disguise.

 

3rzs just have an oil pressure switch no actual sensor.