Show your 285/75/16 and 285/70/17

HOLY sliders...

 

Are they offset (one at 5 and one at 4) or did you use a spacer on the drivers side? How much lift did you get? I'm planning on doing the 6112's set at 1.5 of lift and adding some spacers to avoid to much preload but want to run 285's. Just curious to see what other people are doing and how they ride. Thanks

 

All of these look awesome! I’m having second thoughts about 285s because everyone talks about trimming. I’m not about to do the cmc, just don’t want to get into that. I don’t mind trimming a little plastic and I’m already running spacers. Have all of you guys done the body mount chop?

 

I run 285/75r16 ko2 on stock wheels with spacers, no cmc, small amount of plastic trimming, no rubbing

 

What suspension set up are you running?

 

Icon extended travel in front, toytec aal and shock in rear.

 

I'm going a cmc this weekend. Camber 0, toe 0, castor 3*+ good to go?

 

Sorry don't know the part number. It's just a center cap for a different style rim.

 

OME 888/bilstein 5100, 1/4 spacer left side, custom uca’s @Dynosports up front. Dakar leaf packs long overload removed, bilstein 5100 ext travel, timbres bumpstops w/ubolt flip kit. *this was prior to bumper winch.

 

285/70/17 with plus 1mm offset and 2" levelling kit. No issues with rubbing.

 

What mud flaps are those.

 

Hey man,
I have a 3" OME lift already, and I'm really considering the 1" body lift as well. Any pros/cons?
Is this an easy install I can do? Did it mess anything up apart from a gap in the rear bumper?

Thanks!

 

I just got my truck lifted with 285/75/16 and I was wondering what tire pressure you guys are running on them?

I googled haha and it said to weigh the truck front, back, and the whole truck. Then get the payload of the tire and do some calculations. Did any of you guys do this?

Here’s Groot:

 

look up chalk test on youtube a good and easy way to get proper pressure

 

Yes use the chalk test.

Looks good, what lift?

 

Bilstein 6112/5160 with a 1/2” spacer and Dakar heavy pack.

 

Looks really good and I've been looking for someone who has a 1/2" spacer with 6112's. This is the same set up I want to run even the tires but I'm going with the medium duty Dakars in the rear. Are these 3rd gen 6112's and what clip setting did you go with up front? Also have you measured hub to fender?

 

My new 285/70/17 Falken wildpeaks just arrived can't wait to slap these bad boys on

 

Thanks!
Yes they are the 3rd gen. I have the set at the 6th notch and 5th notch. I didn’t get measurements from the hub just from the floor to the fender prior to the lift.