Socal - $500 Rear Bumper Pelfreybilt Modified high clearance w/ swing gate

Selling a Rear bumper pelfreybilt modified high clearance bumper that has been sitting in my alley for several years. I removed it when I bobbed my bed and its been sitting there ever since.

$500 - Cash only
Local Pick up Only - Socal/Fontana


Modifications:
Bumper sides are cut shorter to match an extra 2.5-3" wheel well chop out of the bedside
Welded bed side guard tubes
Swing gate has mounts for quick fist mounts for a shovel
Supports for 2 rotopax

Issues:
Doesn't have the trailer hitch / receiver
Spindle has a bit of rust, will need to be hit with a scotch bright pad but should be fine.
Swing gate bearings have been outside for several years, will need some cleaning or elbow grease. I shoved a paper towel in the bottom to stop any dirt from getting in the bottom...but its been sitting outside for years
Chopped off part of the Hi-Lift mount to redesign it but I don't have the energy or time to put a new one on.
Including the Rotopax, but one of them has a little rock rash, its been a long time since I had any gas in them but they both sealed fine last time I used them years ago.
Missing the wear/slide plate for the swing gate lock pin
With the bed side guard tubes you need to "pull in" the bed sides with the mounts/stablizers so they don't rub too bad on the guard tube.
Bumper was used heavily rock crawling, will need some elbow grease and a coat of rattle can
Bumper lights NOT included



This is what the bumper looked like before removing it and chopping off the top of the Hi-lift mount

 

I would come get this now but I am in Idaho

 

You need the matching set!

 

I very much agree.. however this is what’s stopping me haha


free bumps though for this bumper, sure it won’t last long on here