SOLD Fox 2.5 Extended travel non resi

I am selling my 2.5 Fox ext travel shocks due to my acquiring a new set with adjusters. They have about 7,000 miles on them and have king 14” 600lb coils installed. I will throw in the stock 13” coils with purchase. These are located in Connecticut. Asking 650$ as you see it in the pics. Thanks!!

Sold mods please close

 

Where are you (and the coilovers) located?

 

Sorry, updated original post. I am in Connecticut!

 

How did you like the ride on these? And, were you running extra weight on the front of your truck--bumper, skids, dual battery, sliders, etc.?

Interested and could possibly pick up next week if you haven't sold them already...

 

honestly I loved them, have a bumper and alum skids. they rode great, just upgraded to adjusters..

 

Did these require after market UCA’s?

 

i have this same setup on 700# springs. Running aluminum plate bumper, winch with synthetic line, and front IFS skid on a V6 double cab taco.... I feel like the 700# is a bit too much personally, but i don like the additional support to keep my nose in the air. I really should have tried the 650# springs just to be certain... Probably going to buy some down the road.

I had 600# on the coil overs when i purchased them, installed them on the truck, set it on the ground and the entire front end was almost setting on the tires. After putting 2.5" of preload i was able to drive the truck without rubbing the tires, however a good bump would still cause the tires to rub.

 

any lift over 2" needs UCAs to get a good alignment. Most of the UCAs have caster built into them to help out. OEM UCAs are pretty maxed out at 2.5" of lift.

 

I believe to get required caster, yes they do.

 

Right, and these are the 600lb 14" springs

 

bump, price drop

 

Would you be willing to ship?

 

Yes sir

 

Sorry for asking questions on your thread but I have a 2019 SR5 and I’m getting some Fox 2.5 Coilovers and I had some questions that I can’t find in searching.
I have no extra weight. I’m looking at Fox 2.5

$1,594 880-06-418 Rear Coilover Shock Absorbers Fits Toyota Tacoma

880-06-418 with 600# springs. I currently have OME/Bilstein set up at about 2” to 2/14” of lift. I want to have the same lift with these new Fox Coilovers. Do I need the 14” springs? Why did you replace the originals with the 14”? Thanks for the help!

 

You don’t need the 14” springs but with them you can add a little more weight, ie bumpers, winch, sliders, without running the compression down further.. if you want a better answer, head over to the Fox life thread or shoot @AccuTune Offroad a message. They are super helpful guys

 

SOLD!