SOLD - Pro Comp Traction Bars and brackets $160 [NorCal]

Purchased from another member but ended up not using.

Designed for Pro-Comps 6" lift kit but will work as long as you have 1.5" clearance at rear leafs/axle (i.e. block or similar)

Requires drilling two holes into frame and plate mounts on axle with rear leafs.

Simple design and only one I have seen with 2 sides to even out any force from axle wrap. Does interfere slightly with ground clearance but not too bad. The bars themselves are pretty tough so they can take a beating.

Local buyer much preferred as these things are very heavy and large. It would be at least $100 to ship and buyer arranging shipping is preferred. If buyer has a freight option I can drop it off.

 

@tacoma16

 

REALLY ???!!!

Snow drags maybe.

 

Thanks @Thyces. These ones hang a tad lower than I would like, plus I think they are for a double short bed not a long.

@taczilla the axle wrap/hop is getting me a bit concerned. Traction bars may be in the to do list to save my leafs and driveshaft if the problem occurs in the dirt.

 

I don't think they are specific to long or short bed. There is only one part number for them. Since you have to drill a hole in the frame to mount the front brackets that is what makes it fit.

 

Good to know. After looking at them a little closer I think they won't work with a u bolt flip kit that I have.

Good luck with the sale.

 

If you still have these, would like to find a way to get shipped to AZ. How do I pay you? How can we find shipping cost?

 

...or, if close to SD I can pick up

 

SOLD