SOLD - seat spacers

Bump

 

interested as well

 

This sounds stupid, but I have no idea .. I only know how to make them, haha.

 

i would imagine this would only raise the rear. unless there were spacers at all four corners. maybe @tonered or @ccotner112 could clarify.

 

Okay, so those are sold. Once I know that they work it will not take me long to knock out the rest. I can't imagine any hiccups, just playing it safe.

 

Will these work on the 2nd gens?

 

Count me in and PM me to take all my moneys when ready

 

Count me in for a set also!

 

Wow! Those look killer compared to my printed ones.

Nice work, Rick!

 

Hey, Folks.

These only raise the rear of the seat to help with seat bottom angle (that was important for my wife) and add some height if you are having trouble seeing over the hood.

To change the front is a lot more difficult since the bolt is almost horizontal. To get it raised with a fitting would probably require it to go up at least 3in. That creates a lot of issues.

 

The Tacoma seat bottom is already flatter than most seats. Raising the rear would make it even flatter. But then again it might take some weight off tailbone and transfer it to back of thighs, which might make it more comfortable.

 

All the cars that we have had were equipped with electric seats since 1995. I typically set them all low as possible front and rear. I am comfortable for an entire day stock in the driver's seat of the Taco. My wife was not comfortable for even short drives and the spacers fixed that.

I rode over there while the wife and daughter were driving. It was okay. I did notice the difference.

 

Put me down for a set. If it doesn’t help me, I’ll just sell it on. Currently I can’t stand my seat for more than an hour or two, whereas in my wife’s Outback I could sit all day.

 

I'm interested in a set, please pm me your paypal info
Thank you Sir