SOLD

These panels are left over from prototyping a MOLLE panel that goes behind the rear seat of a second or third gen double cab Tacoma.

Each panel has a number on it that corresponds to the description below

SOLD AS IS
I can't guarantee fitment unless you buy a production panel ($310 shipped)

#1
This was a panel where I decided to try bending it Midway up rather than at the top below the header board. The five holes along the mid center line align with the holes in the cab but the top seat back latch holes do not align. These could be redrilled and this panel used.
$120

#2
This is a part of a panel that goes on the driver side of the cab. All holes are very close to aligning or do a line. Panel has been sanded in prep for paint but never painted. Grid pattern holes are different sizes.
$40

#3
This is a portion of a panel. Not entirely sure which portion see the picture for sizing
$20

#4-10
These are small portions of a panel that are left over when a panel is cut to accommodate the power window on a third gen Tacoma. These would be great mounted next to the shifter or on a door panel. I have trimmed and painted one to show you what it looks like finished
$15 each

Buyer will pay shipping however it shouldn't be too much.
The biggest panel shipped from California to Florida was $50 (estimate)

I am located in Santa Ana CA
Local pickup preferred but willing to ship

$170 OBO takes all!

 

Photos?

 

Sorry, phone was struggling haha
Pics should be up now

 

I am interested. How much to ship it all to 37920?

 

I picked a random address on Knox TN
Estimate was $56

 

I will PM ya