SPod with “factory” switches.

Has anyone installed an SPod and used the factory looking switch set up?
I was looking at this....
https://www.4x4spod.com/tacoma_dash_switches_05_12_tacoma_no_switch_panel_spod

And was wondering if it would work even though gen3 trucks aren’t listed.

I pretty much want an SPod to be run to three factory looking light switches and a compressor. I don’t want any of the switches they provide.

Any suggestions on which SPod to get?

 

You could most likely go with the basic 6 switch system and just do different switches somehow.

I've got the power module sitting around with no switch banks or harness if you're creative enough to use that to build out what you're looking for?

 

Thats what I was thinking, I was wondering if anyone has done something similar and had any recommendations as far as which SPOD to go with. I believe the one listed above is the least expensive and would do the job.