Supreme suspension 3"lift kit help!!!!

i just had installed a 3" front 2"rear block lift kit with differential drop and sway bar bracket. And i notice tha around 30mph and 55pmh i hear and feal vibrations comming from the front does anybody knows whats wrong shoud i take out the differential drop or the sway bar bracket i seen alot of videos of readylift kits being install and the reviews are good whats so different than mine?

 

Take out the diff drop and see if the vibe is still there

 

I"ll try that because someone told me to actually add more which i did but no improvement

 

https://www.tacomaworld.com/threads/drive-shaft-vibrations-solved-step-by-step.244535/

Nearly everyone with a 3" lift has these issues.

 

The vibe is one of two things, the front driveshaft from the transfer case to front diff or from the left front cv axle / needle bearing on the diff.

 

Umm he specifically said the vibe is from the front end guys

 

Did you get your wheels / tires road force balanced and an alignment post lift ?

 

Yes alignment and tire balance today and still does it but if i put it on 4wdrive it actually stops and as soon as i swith to 2wdrive it comes back again

 

Thats needle bearing

You need the ECGS bushing

 

The two shops that i stop to ask about my problem say that they install readylift and roughcountry kits and they had never had this problem

 

Hey now I said it first, the USA gets this point there Canuck

 

Link him the thread then sparky

 

There is a very common problem that occurs with a shitty design by Toyota in the front diff. Where your drivers side front CV axle inserts into the diff there is a needle bearing with a lot of " slop " in it. The further off axis that cv sits the more that issue shows up. A company called East Coast Gear Supply makes a solid bearing ( polished cromoly sleeve ) to replace that sloppy needle bearing with. Search ECGS on this site and you will find a ton of info on it.

 

But as soon as they installed the lift kit the vibrations began and the truck only has 30000 miles how so

 

https://www.tacomaworld.com/index.p...bearing-vibration-thread.152173/#post-3045074

You're welcome

 

Yes, exactly that is because your CV axles are sitting at an pretty nasty angle now whereas at stock height they were nice and level and rotating all happily and smooth. Now that your cv's are doing this / \ they are not happy anymore, at least the bitchy drivers side one isn't. It is any easy fix, just buy the bushing and the special needle bearing removal tool and its an easy 2 HR job in the driveway.

 

Do you guys think that it will help if i bring it down to 2" lift in the front

 

Any idea on how much for the bushing

 

There's a link to the ECGS site in that thread I posted