Tacomas doing work

Must have for ice fishing. Auger is normally mounted on the front rack. Pretty sure one of my buddies was out using it at the time

 

Clearing land to build our house. I hate splitting western juniper but going to keep adding to the holzhausen as I go - first time trying the circular stack.

 

That’s an interesting rack setup you have there. Would you share what it is?

 

Our friends are trying this for the first time as well. This was last September. Mainly Larch. I'll have to ask them how it's worked for them when we see them soon.

 

3rd Gen and Bison ZR2 loaded up.

 

It’s a Leitner rack. Found it used for cheap and really like it. Very modular and the rear top bar sliding forward is what sets it apart. You actually get a useful truck bed back in seconds when you need to haul. Adding the big side toolbox is killer storage too and doesn’t take up any bed space.

They already seem so much sturdier than rows and take up less space.

 

quick dump run with some yard waste

 

Water leak duty.

 

they are very handy

 

Towing my XJ

 

Trimming some oaks to give the yard a little more sun, and cut down on leaf raking next fall. Taco did just fine towing the rent-a-lift. The lift was fun, especially the higher you go!

 

Rock and mortar for a remodel project.

 

Rita sitting low with a load of sod

 

Taco wins the battle.

 

Cleaning some wood out of the yard and dropping off at my buddy's house.

 

@$500TRD you should post the pic of your firewood load.

 

Little yard work today..

 

Picked up some more wood for the pit

 

Dumping shįt

 

Picked up two pre-made fence panels to replace old wind damaged ones at my mom's place.
The Diamondback cover is great for oversized cargo.
Plus my Dobinsons springs didn't even notice.