The Lair

Seconded

 

I even tagged him to remind him this thread still exists.

What about you guys? Do you understand offset/backspacing well and can help me figure it out? Lol

 

Every time I think I do, I try to explain it to someone and feel like I know even less than I did before I started talking.

 

I used this to help me with my decision. this helps visualize

Here's another option

 

Looking like about 1.9" more poke than stock. Where that lies for you, I'm not sure. Measure 1.9" off the outside of the tire and that's where you'll lie approximately.

 

I’m alive, I think! Just been busy. I understand wheel specs pretty well so I’ll reply more in depth later when I’ve got some time.

 

Get out. This ain’t your house anymore

 

So it's a jeep build thread now?

 

No, somebody's LS swapping a Jimny.

 

Actually. The current project/build is an 07 cummins mega cab dually.

 

A giant of a truck.

 

Purchased at auction as a theft recovery after getting stolen to take the welding bed off

 

I found a bed in Victory, Tx & drove 5 hours 1 way to pick it up

 

They stole it for a welding bed? There a hot market on those?

 

This is the rear after getting a 1” lift block, helper towing bags, & a black rear bumper to color match.

 

Here I did a 3” lift spring lift & new shocks. Used OEM hood & right front fender. I swapped out the grille to one that could be color matched. I removed & replaced the huge bumper cover with an OEM bumper and a bumper cover off a Laramie that can accept color. I also installed new fog lights & new nightrunner edition headlights.

 

Next up is new steering gear box & brace, steering linkage, upper/lower ball joints, pads/rotors, drop pitman arm, & adjustable tracbar. The bed is pretty much ready to install & she will get sent off to paint.

 

Hot market in Tx because of the oilfield work. And the fact they are upwards of 8-10k without equipment

 

What is this for sale feeler nonsense????

 

Dang it Ryan, you’re not supposed to tell these guys.