The LED SAE J583 Fog Pod & Fog Light Review

Don't forget the DD SS3 pods, especially since there is a similar visual appearance between the Squadrons and the SS3

 

I assume that's from BD, not your retro kit? I think there needs to be a picture of them installed on the unit so you can see how the lens appears from the "viewer's" perspective.

 

I wanna know how bad that’s going to hinder performance I don’t care so much about looks.

 

The shield is behind the outer lens, I don’t think it will be noticeable when installed on the light.

The image was supplied by another member who received their retro kit.

 

@Diode Dynamics will you have the lenses on your website soon? I plan on putting clears on my yellow fogs before I do the install.

 

Just checked and my retro kit is out for delivery today. I'll get some pics from the front, might install them if it warms up some here. Not a cold weather fan.

 

You don’t have to install them to give some input on output

 

The lights are currently on the truck. I'll throw them on one side and pull to the other garage door for a quick comparison. Hoping the kit won't murder the output but we will see.

 

remember, you are looking at the backside. the fronts still look yellow.

 

Or clear...

 

Based on this review I purchased a set of the KC G4s. When installing I discovered that the factory fogs only had one screw holding them in place, probably a by-product of past Pelfrey installation work (they left a lot of fasteners out when reassembling). Does anybody happen to know what size the screws are so I can go to my local hardware store instead of the dealer? I can't take one with me as an example because I would have to un-install the lamp.

 

Got the kit in, comes with new screws aswell as o rings. Picture from the front. Not to bad but will see once it is on the light.

 

3rd gen only have the 1 screw with stock TRD fogs

 

As mentioned above, 3rd Gen only have one screw. 12-15 2nd Gens have two screws.

 

Image doesn't work.

 

Purrrfect.

 

Retro fit kit on the left/passenger side. Drives/right has the original sae lens. Note I have not yet aimed the retro kit yet, its actually aimed down compared to the original. To bright out to see on garage door, holding a board in front of them 6 ish feet out the original has significant overspill, the retro fit kit did not have as much. Once I get the other side on I'll have to scroll though here and find the aiming measurements again. Hope this helps, and I know it's not a yota, yet, but Crashnburn is a genius in these lighting stuff, plus this community has be way more friendly than the F150 forums lol

 

Very interested to see your input and maybe some pictures when the sun sets