Tool Kit /receiver tubes need to change lower ball joints?

Anyone have a tool kit # or the required receiver tubes to change the lower ball joints on a 2010 ?
thanks

 

I know this guy has it. @nastyneight

 

Autozone?

 

I have the HF kit, and then found a piece of pipe that was the right size and used it. Don't think the HF kit had the right one, without buying the extra fit kit

 

And not going to lie it sucked

 

I got the Matco master set ( same as otc) I haven't run into a situation where I needed another adaptor

 

Far superior kit than mine tho,

 

I also spent 700 bucks on it. I have the cheap harbor freight one at the house and just use it as a u joint press.

 

Not gonna lie? You told me you stuck an impact on it and BRRRRP it was out.

 

I pop the new ball joints in the freezer overnight and then I warm up the control arm with a torch and then put a little grease on the ball joint and they slide right in every time.