TRD CAI Acrylic Cover

Looks good installed.

I have a few of these left.

When this batch is gone, I will not be making any more.

 

How come?

 

There is a company that is across the street from my office that makes industrial models. They have a laser suitable for cutting plastics. They have been cutting the acrylic materials that I need off of patterns that I send them.

They are going out of business next month.

 

oh that sucks. I'm glad I got one from you when I had the chance.

 

I have a few left.

 

Bump.......

 

Send me an invoice for a cover stating "supercharged by TRD" would ya

 

PM sent.

 

Have any unetched clear left?

 

I will need to check when I get home.

 

Ok

 

Messaged.

 

Do you have any of these left?

 

Message him. I'm pretty sure he does, he did when I spoke to him.

 

I do, however on a recent batch of the AFE CAIs that do not fit as well.

The CAI is a molded plastic and is not dimensionally stable. It can flex a little. I have has a few people pm me that they have had problems fitting these.

I have sold a lot of these, but I have had probably 5 or 6 people that have had a fitting issue.

The clear & tinted plastic covers are fit close to the edge of the cover. The aluminum ones I make do not fit as close to the edge. As a result, you are more likely to have a fitting issue with a plexiglas version versus an aluminum one.

I have taken a CAI that did not fit well and put in out in yard on a hot summer day and let the heat soften the plastic on the CAI and I was able to get the cover on. Once the temperatures cooled, the cover fit fine.

If you want one, plexiglas or aluminum, I have them in stock.

 

Boo. @Coupe I need another one for an AFE Stage II SI CAI. I broke the first one. Completely my fault. I ordered the wrong one and tried to adjust it to fit, and then lost a bunch of the rubber washers which i come to find out allow you to tighten the screws and not crack the plexi glass lol. Plus I got to carried away sanding and scratched up one side. So thats in the trash now after i threw it across the room because i was to impatient to find where the rest of the rubber washers had rolled off to, and cracked it while tightening the scews. LOL.

 

I still have them in stock, I will be glad to fix you up.

 

Please check your PM-I forgot to mention I have the afe cai-Thanks

 

Just found this. Wanted to say they look good!

Which gives me a way to find this someday when i have forgotten where they are and actually buy that Volant intake i want.

Spec U headers are first, and a mid pipe. And hell a smaller pulley for the s/c.

BUT i will get there! Someday..

I would be there now but i had more clutch woes on the turd and thats another $800 pluss out the window. Factory clutch couldn't hold the power, URD stage 3 was good but somehow half of the pressure plate bolts backed off after 10k miles. Just decided to do the new heavy flywheel and a stage 2 from URD as I am not sure what caused the problem before, and the 3 had a little too much chatter towing.

 

I have retooled this a little and the new ones fit much better.