TSS BRAKE WARNING MESSAGE!

INSTALLED 3 INCH SPACER AND HAD A BRAKE MESSAGE POP UP WHILE DRIVING NOT BRAKING AT ALL, I BELIEVE THIS HAS TO DO WITH THE TSS SENSOR BUT NOT SURE. ANYONE HAD THIS PROBLEM COME UP? THIS IS ON A 2019 TACOMA SR5

 

The TSS may not work correctly with your lift kit according to Toyota.

 

3” up front only? The truck needs to maintain some rake for the TSS to work properly.

 

BUT IT NOT WORKING RIGHT WOULD IT SEND THE BRAKE MESSAGE WARNING, CAN I JUST TURN IT OFF AND NOT WORRY ABOUT IT

 

YES JUST 3 UP FRONT, IT SITS 1 1/2 HIGHER IN THE FRONT

 

IF I ADDD A 1 INCH TO THE REAR WOULD IT HELP OR WHAT

 

Not according to Toyota. There was a TSB about this and if the truck was modified at all (lifts, larger tires etc) Toyota would disengage it after performing the TSB.

 

Yeah, that much bro lean will mess up TSS. The system needs to be able to "see" the roadway to function properly.

 

OK COOL I ORDERED 1.5 BLOCK FOR THE REAR. AS FAR HAS THE TSB TOYOTA CAN TURN IT OFF SO IT DOESNT WORK? HWTA DO THEY CHARGE

 

If your vehicle falls under the TSB, its covered under warranty.

 

yo chill on the caps lock lol

 

If your truck is covered under the recall, you should have received a notice in the mail. You can also check on the Toyota website to see if it's covered. You can disengage it also. The procedure is in the manual.

 

Get the trd pro grill... this will move the sensor down about 3-4 inches. From there you can put some shims (washers) into the bottom of the sensor to adjust its angle down a little bit. This should compensate for the lift and the squat.

 

OK THANKS FOR THE HELP!

 

Does a new sensor come with the trdpro grill?

 

No, it uses the same sensor, just moved down the little bit.

 

CAPS are loud and yelling is assumed, Lower case letters are soft sounding and no yelling is implied.

 

OP gives zero forks
Bro lean

 

Almost Friday OP