TTC ☆ OFFICIAL

Some hammering may have been invovled

 

Hammering beers

 

When you go to install them pack the bolt hole with a rag or paper towel to keep the bolt from spinning while you start the bump. When I did mine with the front jacked up but fully assembled I could not get the room to have the Allen wrench the the bolthead and start it.

 

I was going to attempt it with the tire on

 

You should be fine I didn’t have to jack mine up. But with the tire off you can get some more leverage if it’s tight.

 

That’s what she said

 

Great day, been stuck since 8:15. Luckily we have a little drama going on between the supplier and the carrier (me) so I’m getting well paid to wait.

 

Just did two 12's & to finish it off, had to log a 16 from Hell....and now all the beautiful People are askin' me to just be Smiley Face & there Meeting. Had to finally say Lets get on with it!

 

Terrible, this is my Pov right now.

 

Get your feet down and get to vacuuming!

 

Nah we have someone who gets paid to do that from the school(an well to). I’m facing the stairway in case boss woddles up to not catch me nappin.

 

Well I got the passenger superbump on but I can't seem to tighten it. I think I'm going to have to go to buy a floor jack now. Luckily O'Reilly and AutoZone are a block away

 

Use a block of wood an stock jack

 

Howdy, afternoon TTC crew!

 

Bought a cheap 2 ton floor Jack and cut a piece of 4x4. Works great. Got the drivers side all done. Passenger side is taking forever to torque down. The driver side I was able to spin the bump on pretty good before I had to use the Allen wrench.

 

Where's the pic's

 

Sent you a Txt .

 

X2

 

Want be able to look at till tonight cell phones don't work in the mine. PM through TW