1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Upcoming susp swap, hardware sizes and "what else?"

Discussion in 'Suspension' started by deanosaurus, Apr 10, 2021.

  1. Apr 10, 2021 at 4:25 PM
    #1
    deanosaurus

    deanosaurus [OP] Caveman

    Joined:
    Jul 23, 2018
    Member:
    #260241
    Messages:
    2,174
    Northeast Region
    Vehicle:
    09 TRD OR AC
    Hello friends,

    Getting ready to tear down to strip and POR the frame, and while I'm in there, putting in 5100s/885s/Dakars (I know, I know, factory leafs are tired AF and saving for Deavers)/SPC uppers. While I'm in there, I'm putting in the ECGS bushing. I have new U-bolts and their nuts/washers.

    I believe the leaf eyes and the shackle use the same size bolts in all 6 holes (3 on each side), M14x1.5x100mm, so I'll be replacing those as a matter of course with Grade 8 stuff. Can someone confirm this?

    What other hardware (with sizes if possible, please and thank you) am I going to be touching while I'm doing this, so I can go ahead and just put all new stainless HW in?

    What else should I consider while I'm in there?

    Thanks!
     

Products Discussed in

To Top