Viper 5901 Install on 2011 Tacoma

So I have all the components ready and soldered what wires I could before moving everything into the truck. The only issue I have now is knowing where the wires go inside the truck. I've search everywhere I can for the wiring diagram for the 2011 model. I found a list that explains the color of the wire and where it is within the truck.. But its not precise. It just gives me a general area where it is. When I start looking for the wire I find several that match the color given on the sheet.

Looking for help from anyone that has installed this alarm on a 2011 model. If anyone has a wiring diagram for the 2011 model that would be great..

 

I doubt much has changed from 2009 as I don't believe anything new has been added.

http://www.the12volt.com/installbay/forum_posts.asp~TID~116681

Hope that helps!

 

Ill give it a shot and see if anything has changed. Thanks!

Ok I have two more questions:
1. Can I use one common wire for all the 12V constants wires used in the system? And a common wire for all grounds??

2. Theres only one green door trigger input wire... but theres four doors. Does this wire just go to one of the doors or does it need to go to all four?? If it does go to all four how would I do this??

 

1. Yes, it is advisable.
2. If you press your door lock button all four unlock/lock right? Only one wire is needed.

 

Thanks.. I found all the wires Ill need. Hope this works out ok...