Wait, the Level 8 MK6 IS BACK?!?!

Are these available to pickup in store? Haven’t had a chance to check out my local store yet, but the $480 shipping for wheels and tires is kinda stopping me as of now

 

I didn’t pay shipping @DiscountTire Direct and payed around that for the wheels.

 

Hi, c808nner-

We do not have a brick and mortar presence currently anywhere in the Hawaiian Islands.

 

17x8 with 4.1 backspace

 

So after doing the rear lift. I made sure to also pay attention to trying to center the rear axle as perfect as possible and I came to the conclusion that unless you have wheels with some "poke" you would never notice the axle wasn't exactly centered from the factory. I came out with a better look with everything squared away. i also notice that after the alignment where everything was put into specs, as it should be, the front wheels moved in a bit more, however it probably helped with rubbing. They still poke a whole lot compared to the original wheels but they moved in quite a bit. Great looking wheels but the finish is very sensitive. I have marred the wheels already(my fault) but I suppose it's fine as i can always refinish the wheels in a few months to make them look new again.

 

17x8 0 offset Bronze

265/70/17 Faulken Wildpeak AT3W

 

265/70/17 17x8 0 offset

 

Awesome looking Tacomas. Thank you for sharing.

 

I've been looking at wildpeaks for a bit now and seeing them on the black mk6 definitely has me ordering AT3Ws soon. Thanks

 

I'm assuming you don't have spacers?

 

No, 0 offset is the perfect amount for 265/70/17's with a 3" suspension lift & UCA's.

 

Do you guys have this 17x8-10 offset in the bronze. I have the same in black but want different color lol

 

Hi, Miguel-

The 17x8 ET-10 MK6 in the matte bronze finish is sold out and currently on back order with the manufacturer (no lead time yet). The 17x8 ET0, however, is readily available in matte bronze if you're interested.

 

What about 16x8 in -10 in gunmetal? Do you happen to know the backspace on those? Thanks

 

Hi, outxider-

The backspace for the 16x8 ET-10 works out to ~4-inches - see HERE for more on offset and backspace

This wheel in the matte gunmetal finish is also not available but replacement inventory is on the way and should be available early to mid December

 

Thanks for posting this picture. I wondered what the bronze would look like on a silver doublecab. I’m undecided between bronze and gunmetal.

 

How do you remove the "8" from the center cap?

Just picked up a set of 17x8, for a pizza cutter setup (255/80-17)

 

I used a little nail polish remover on a microfiber and it rubbed off fairly easily.

 

I used household goo gone. Wipes right off. Others have used acetone w success.

 

Thanks guys! Will give it a go.




I am happy to say the MK6 rims clear my Stop Tech 6 piston BBK! I'll post pics in a few days when I get the tires mounted.