1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

weld on exhaust tip fitment

Discussion in '2nd Gen. Tacomas (2005-2015)' started by mgrande, Feb 23, 2010.

  1. Feb 23, 2010 at 1:02 PM
    #1
    mgrande

    mgrande [OP] iKill

    Joined:
    Apr 11, 2009
    Member:
    #15830
    Messages:
    5,363
    Gender:
    Male
    Raleigh
    Vehicle:
    2011 TRD off road
    Kings, AP 3" leaf pack, timbrens front and rear, TC UCA's, pro comp 7189's, baja ATZ's, CBI sliders and rear, relentless front, dynomax catback
    I just want to double check and make sure I'm getting the right size. I'm pretty sure I'll have to cut off my stock tip and weld on this one, specs are 2.25 inlet, 3.5 outlet, 12in long. Here's the link
    http://www.summitracing.com/parts/JEX-IRAC31212-BV/

    Do you think the finish will hold up? I haven't seen anyone on here running one of these yet.
     
  2. Feb 23, 2010 at 10:26 PM
    #2
    hemitruk

    hemitruk Old man , young boi truk

    Joined:
    Oct 17, 2009
    Member:
    #24461
    Messages:
    2,268
    Gender:
    Male
    First Name:
    Kurt
    Hawaii
    Vehicle:
    2010 Dbl Cab Sport,
    A few
    If you cut tip off the pipe is 2 3/8 in.Might wana double check but when I measured mine it was 2 3/8 in before it flares out.I ordered MBRP 2.5 inlet 3.5 out let X 12in.Suppose to get it by thursday .Powdercot is strong. should be fine.
     

Products Discussed in

To Top