What Have You Done To Your 3rd Gen Today?

Nice who’s bumper? I did the caps also.

 

Archive garage hammer hangers and DIY crossbar by sibi built. Beef!

 

I just installed the Course Motorsports phone mount. It took a whole 5 minutes to install. Looks good and seems to hold the phone securely.

https://coursemotorsports.com/collections/toyota/products/toyota-direct-fit-magnetic-phone-mount

 

Pic of this installed please!

 

I got high but I used protection. @Ironman4x4America 3" Foam Cell Pro stage 3 lift kit and skid plate kit went on today courtesy of Todd Zick at ZFab here in Rapid City. Initial impressions around town are good. Small bump compliance (railroad tracks, sunken manhole covers, rough surfaces) is very smooth. Rebound is far better. The truck feels far more stable in corners without the typical body roll. I'll know more after tomorrow's allighnment and Friday's first trail run. Still deciding on my tire/wheel combo but I'm close.

 

Nice! My hammer hangers have arrived and I'm just looking for the time to install. Was it very difficult to remove the riveted OEM hangers?

 

Looks great. I thought about doing this to my new truck to match my brown 85. Don’t know how it would look on white.

 

Had the dealer take mine off before I picked it up.

 

Just a couple hours south of the OBX

 

Haha I'm from Seattle and have been to Vancouver many times. You are spot on! That's why I moved to the Midwest away from all the insanity.

 

have one on order, just waiting for the last week or so...

 

Great Pic, took the truck to the beach SO FUN TO DRIVE ON SAND !

 

Rather than spend the money for a replacement part, I decided to paint it…

 

Don’t mind the slight squat. Has stuff in the back

 

Sorry this is at Assateague island , VA.

 

I've considered this since they don't make one for the manual yet. Curios how spray paint will hold up.

 

Looks great at first, I spray painted the chrome ring around the start/button and it has started to scratch up and the chrome is showing again. I think I may try plasti dipping the chrome as a cheap way to cover the chrome.

 

Hope it all works out for you.

 

Replaced the wing nuts with plastic knobs for the traction board mounts.

 

I originally did it with plasti dip - not a good solution for high touch areas. I redid it today with enamel paint. I’ve painted parts in other cars with the same paint without any issues so I expect this to hold up as well.
Time will tell…..